Joined
·
3 Posts
Has
Alumn. Cyl. Head I6
1 - 3 of 3 Posts
Joined
·
304 Posts
OK
Joined
·
133 Posts
I'm guessing the question meant to be asked was "Has anyone ever installed an aluminum head on a 6cyl motor?" Yes, it's been done before. They can make some serious power, especially with a turbo or twin turbo added to it.
1 - 3 of 3 Posts
Join the discussion
Recommended Reading
-
California chemical warning
Vintage Mustang ForumI've seen this warning on everything now. Got a new shifter ball from MDL and it came with the best explanation of this warning:- 16
- 417
-
ophthos · updated
-
65 -66 side Vent Restore.
Vintage Mustang ForumI have almost all of the pictures to be able too do a pictorial on the restore of the side vent system of the 1st generation FastBacks. Some things I found that were interesting about the whole system would be that there is A LOT OF PARTS. I am talking about the whole shabang. The outside Vents...- 44
- 6K
-
MarkStang · updated
-
Hurst shifter adjustment instructions needed
Vintage Mustang ForumHello all, it's been a while as I have been busy with life stuff (bought a house). I've been driving Jane every day, of course, but I'm starting to get pretty annoyed with the shifter. I've got a Hurst Comp+ shifter that's old as dirt attached to my even older HEH-G Toploader transmission...- 7
- 189
-
Kelly_H · updated
-
Headers & Windsor Jr Heads _ 1966 Mustang
Vintage Mustang ForumI know this has been discussed in the past but I'm hoping that there are up to date solutions for 2011. Same old problem .. What headers to use on World Parts Windsor Jr. (cast iron) Heads that allow for good spark plug boot & wire clearance. I haven't had the 66 Mustang but 2-weeks and have...- 7
- 3K
-
Scott Breaks
Vintage Mustang ForumIt looks like I may have to rethink this single pot mc thing...- 7
- 191
Join now to ask and comment!