[CantedValve]

I am mocking up the quarters and corners on a 1970 sportsroof. I think I have this right, but need a double check. I think it’s right except for the taillight panel needs tucked in behind the corner. Am I right?

 

[wills70]

Hope this helps

 

[BirdOPrey]

This is how I did mine. If I may make a suggestion. Assuming you haven't already started welding, assemble all your pieces using sheet metal screws and test fit your trunk lid and your rear glass. It's a lot easier to massage this stuff at that point than it is after you start welding.

Art.

 

[BirdOPrey]

Opps, I forgot to post a picture.

Art.

 

[CantedValve]

That is art @BirdOPrey ! And yes, we are using sheet metal screw and clecos to mock up.

Thanks @wills70. That is how I have set up. Will test both corners and the taillight panel today.