Vintage Mustang Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
114 Posts
Discussion Starter #1
I know this is similar to the SD rant post from last week, but I just have to vent. Another manufacturer I plan to avoid is KSR. I purchased three (3) sets of the "MUSTANG" pin letters. Talk about junk. Several of the letters would not even fit the factory holes, and the letters that would fit were crooked. @#$%^&! JUNK and a waste of money... The Scott Drake letters were not perfect, but at least the fit the holes properly.

Email response from the President of KSR:
"Ours are made to fit 65- 66 only. Not 67 . We copied ford ones from a 65"

What BS. The label on the package states
PIN LTRS SET 65-70.

:thumbdown: :thumbdown: :thumbdown: :thumbdown: :thumbdown: :thumbdown: :thumbdown: :thumbdown: :thumbdown:
 

·
Registered
Joined
·
10,221 Posts
Whose label is it, KSR or the Mustang shop's?

MU did that to me on a Classic Tube front disc brake line set. I have a 71, they sent me a "71-3" front set, which turned out to be the 73 set and required adapters to fit my 71 m/c. Right under the MU label that said "71-3 disc brake" was the Classic Tube label, stating "71 disc brake".
 
1 - 2 of 2 Posts
Top