G
Guest
·Guest
Joined
·
0 Posts
Is there any place on the net that shows Ford head stats (amount of cc combustion chamber valve sizes) for each year (stock heads)?
Any page on the internet
Join the discussion
Recommended Reading
-
Bad hesitation after ignition left on.
Vintage Mustang ForumI screwed up and left my ignition switch on for a week. I think I damaged my PerTronix Ignitor. I was working on lights and accidentally left the keys in the run position for a week. The battery was completely dead. After charging the battery back up it fired right up! I was relieved but then I...- 7
- 123
-
Steering jerks at high speed only
Vintage Mustang ForumJust got my alignment done by a real good old school alignment shop. He said went as far he could with caster and adjusted the gear box. It runs great, but on the highway it feels like it wants to jerk and hit other cars. It’s hard to control. he suggested it’s the 17 inch low profile tires...- 8
- 100
-
Tools you made or modified
Vintage Mustang ForumIn the quest to try and purge my shop of 30+ years of stuffing stuff everywhere, I came across this. I do not remember fabricating this particular tool, but I'm not gonna toss it in the trash. I even stuck a label on it so my future self would know what is was for. Show some tools you have...- 54
- 2K
-
RV6 · updated
-
Instrument Panel Lighting Issue
Vintage Mustang ForumHello Everyone! I have been following some of your posts on an electrical issue that seemed to be resolved, and I thought it was some awesome teamwork (not to mention, it was a recent post instead of those you stumble on from years back and not know if anyone is still watching it or will...- 19
- 275
-
TN66Mustang · updated
-
No Low Beam after Headlight Harness Upgrade on 1967
Vintage Mustang ForumI just connected the Redline Lumtronix 11653-1B (EH-001) following the simple directions on my 1967 GTA coupe. My high beam work fine but the low beams do not. I switched the relays around to see if one of them was bad but same results. Any advise will apprectiated. thanks jcs- 1
- 29
-
jcsinc · updated
Join now to ask and comment!