anyone in san antonio ,tx
1 - 2 of 2 Posts
Joined
·
1,598 Posts
Call Leo Herrera on Cleo St. and he can point you in the right direction. E-mail me for details if you can't find him *G*
'67 A-Code Coupe
'68 C-Code Coupe (SWMBO's)
'86 SVO 1D
'86 SVO 2A
[email][email protected] [/Email]
'67 A-Code Coupe
'68 C-Code Coupe (SWMBO's)
'86 SVO 1D
'86 SVO 2A
[email][email protected] [/Email]
1 - 2 of 2 Posts
Join the discussion
Recommended Reading
-
Driveshaft Length?
Vintage Mustang ForumHey guys! So I have a 67 mustang and in it I have a 68 302, a c4, and an 8 inch rear end. I’ve tried to look for a driveshaft for a 68 302 and c4 but all I get are driveshafts first a T5 conversion. Does anyone know what length or better yet, what driveshaft I can through in the 67? Thanks!- 4
- 100
-
Carb issue (maybe?)
Vintage Mustang ForumHello there, My 66 289 2bbl has become hard to start. Tried starter fluid but no help. Once it does start, it will idle rough for a minute and then just shut down. In looking at the carb, I noticed the plate is always open and has a range of just about an inch. (See pic, that is as closed as it...- 2
- 91
-
Seats
Vintage Mustang ForumHi, my '66 coupe came with front aftermarket seats and i am looking for something more period correct. I found some clean '67 fastback seats locally and i am wondering if they would fit in my '66? Also, is there any differences between fastback and coupe seats? Thanks a lot!- 4
- 0
-
drzmat · updated
-
Got my T5!
Vintage Mustang ForumWell after lots of searching, want adds, bartering, "horse trading" I finally have a T5 to put in my car. I'm into it for $150 CAD ($110 USD) From all the research I did this will work fine for my "stockish" Sunday driver car. 1968 mustang 289, 3 speed. I will use my existing clutch and...- 44
- 723
-
Stangfire · updated
-
67-68 A/C Vacuum Lines Through Firewall - Seal?
Vintage Mustang ForumIs there a seal or grommet around the two vacuum hoses through the firewall for the A/C valve and vacuum reservoir (see my index and middle finger)?- 3
- 90
Join now to ask and comment!