Vintage Mustang Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
249 Posts
Discussion Starter #1
I am trying to pull my lecarra steering wheel off my 65 mustang and it doesn't have any bolts to run the puller into just the center splined bolt. A standard puller wont work and I am wanting to pull it to replace the steering box. Any suggestions?
Thanks
 

·
Premium Member
Joined
·
1,393 Posts
I think I made a small plate to bolt onto the outside flange that had a 5/8" tap thru the middle. I fastened the plate to the flange, ran the bolt to the steering shaft and put a little tension on the bolt. I then hit the center bolt, while pulling up on the steering wheel and it came free after a few hits.

After that, I put a little anti-sieze on the splines and it doesn't freeze to the shaft anymore......

Gary
 
1 - 4 of 4 Posts
Top