Vintage Mustang Forums banner
  • Hey everyone! Enter your ride HERE to be a part August's Ride of the Month Challenge!
1 - 1 of 1 Posts

·
Registered
Joined
·
6,807 Posts
Yes the installation is as the other note indicated. I also use (even though the rubber seal is on the hinge and latch brackets) a bit a sealer to reduce (I hope) any rust and add a second level of sealing. Alos (I know its not factory) used staniless steel mounting screws.

If you really get detailed the higes had clear sealant added over the screw heads on 69's .... Only slows done the theives a little bit :(

Jeff Speegle
MCA Shelby Gold Card

http://www.geocities.com/MotorCity/6473
Mustang & Shelby research, documentation

http://albums.photopoint.com/j/View?u=1609818&a=12284202&p=44925357&Sequence=7&res=high.jpg
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top