Vintage Mustang Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
188 Posts
Discussion Starter · #1 ·
I ordered a kit from canadian mustang, and they say that 6 cylinder and 8 cylinder u bolts are the same size for 65 mustangs, is this true,? I need U bolts for a granada rear end and was told by someone that 66 mustang 8" rear U bolts would fit for this application
 
G

·
Yes, 6 and 8 cylinder U bolts are the same. All 65/66 U bolts are the same, 8 inch or 9 inch rear ends.
To bolt the Granada rear end in your car, you will need larger U bolts and the shock mount plates to go with them also, as the housing is a larger diameter than in the 65/66 mustangs.
 
G

·
You can use the original spring plates, but you have to open the hole up by drilling a new hole and using a die grinder to oblong them. Mustangs Plus has done this for years on their race cars.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top