Joined
·
4,800 Posts
Taco Mac on Hwy 9 next to Winward Parkway. Need directions?
Be there, or be square.
J. Boggs
Be there, or be square.
J. Boggs
Atlanta Git-together Tomorrow 7 PM
Join the discussion
Recommended Reading
-
'66 Mustang Front Suspension Project - rebuild kit?
Vintage Mustang ForumI have a '66 coupe with a 289 C-4 auto power-train, and I'm looking to refresh the stock front end. I'm interested in a kit, or guidance on putting together a parts list. I've searched the site for similar strings but most are kinda old. Everything looks worn and sounds creaky when driving...- 11
- 259
-
Spindle Identification Assistance
Vintage Mustang ForumHi All, I was wondering if anyone could help identify/confirm if these are stock Mustang spindles or are they aftermarket? I'm getting ready to order a new brake kit and need to know if it's a stock mustang spindle. Thank you in advance!- 13
- 112
-
Lead replacement options
Vintage Mustang ForumI finished replacing the panel between the rear window and trunk on the 65 Fastback. I now need to fill in the channels where the original Factory lead was used. What is the best solution to use for this? I see Eastwood sells a lead and a non lead option. I’ve seen others say to just use a...- 0
- 0
-
Flade · updated
-
Installing An A/F Ratio Gauge in My 65
Vintage Mustang ForumI decided to use an A/F Ratio gauge to help tune up the dual quad on my 289. I have set the idle and fuel level on the carbs, but I figure if I'm going to do this, better get it dialed in. I read a few articles online on getting this done, and one of the better ones I read was this one...- 19
- 570
-
LeeFred · updated
-
A/C install
Vintage Mustang ForumI am putting factory A/C in my '66. I have a couple of questions. What size bolt was used to attach the evaporator to the dash? How does one get safely get the caps off of the sanden compressor to hook the lines up to it? I need a drain hole cover for the interior, where can I get one of...- 15
- 77
Join now to ask and comment!