Joined
·
6,031 Posts
What is the deal with these blocks (the 351C blocks cast in Australia)? I have heard both ways... some say they are great, other say they are flawed... I know absolutely NOTHING about them... anyone?
Aussie blocks?
1 - 3 of 3 Posts
You might ask the guys at the Fordsix site. There are alot of Aussie guys there. http://www.fordsix.com
1 - 3 of 3 Posts
Join the discussion
Recommended Reading
-
289 Idle Help!
Vintage Mustang ForumHello all, I recently got my engine broken in, and have been working on getting it to idle-- however, I'm having trouble with this. I had the engine between 2,000 and 2,500 RPM for break-in, but when I fire it up and try to get it down to under 1,500 or so, the engine sputters out and dies...- 3
- 58
-
alex1965 · updated
-
1966 Mustang misc cleaning questions. (1969 302).
Vintage Mustang ForumHello i have some misc cleaning questions and "what to dos". 1. I have taken apart the whole engine and working on cleaning all the parts. The heads i have were super dirty and i cleaned with some P360 scuffing pads (pics below). I managed to clean them pretty good on the bottoms but not sure...- 1
- 20
-
1970 FB Headlight Wiring Harness Clips - Side Marker Wiring O-Clip Location
Vintage Mustang ForumI've installed a new headlight wiring harness. There are supposedly four "O" clips for the side marker light wiring, I'm guessing two each side. Does anyone know where they attach? Thanks, Tom- 1
- 13
-
New mechanical fuel pump needed
Vintage Mustang ForumMy fuel pump took a dump this morning. It was one that I got from Speedway that had NPT fittings on both the intake and output sides as I run AN lines. I am looking at this as a replacement: https://www.summitracing.com/parts/crt-m60454 Any recommendations for something better...- 8
- 210
-
66coupe289 · updated
-
Fel-Pro Gasket Snap-Ups Snap Off
Vintage Mustang ForumOkay so I may have goofed. I was putting the one piece Fel-Pro gasket on with the snap ups . I was also using RTV as extra protection and I couldn't get 2 of the snap ups off after putting my bolts in. Then they snapped off. Can I claim to be the first dumbass to do this. Go ahead I can take it...- 1
- 43
Join now to ask and comment!