G
Guest
·Guest
Joined
·
0 Posts
What is the backspacing on rims for the 64-73 Mustangs? Is it 4 1/2 in.?
Backspacing on rims
Join the discussion
Recommended Reading
-
Overheating 66’ GT
Vintage Mustang ForumHi folks My 66 Mustang GT is running high on the temp gauge and today blew down for 30 seconds after I shut it off, making a fine sound during the event. Car ran fine, otherwise. It’s the original 289 but the radiator has been replaced. I’m assuming a bad water pump. Not sure that has ever been...- 2
- 0
-
Woolshire · updated
-
Electric fan and controls for 67 with 20” radiator
Vintage Mustang ForumI’m caving in and finally switching from an engine driven fan to an electric fan for my 67 with a 20” champion rad. The flex-a-lite 398 syclone seems like a decent choice from what I’ve seen, but I’m open to alternative suggestions. I’m seeing a lot of conflict regarding the reliability of the...- 6
- 148
-
AustinE · updated
-
motor mount install
Vintage Mustang ForumGetting ready to drop the 289 into the car. Questions about motor mounts. Should I install the complete motor mount assembly on the engine and then drop it in and bolt it to the frame or install the complete assembly on the frame and then drop the motor and then bolt it to motor or split the...- 0
- 0
-
Bought New Springs
Vintage Mustang Forum67 Mustang 289/C4 no PS/AC I bought a set of C7ZZz-5310-P coil springs and a pair of C5ZZ-5560-4ME leafs along with u-bolts, shackles and eye bolts. The springs are 4.5 leaf 1" drop mid eyes and the coils are 1" drop GT springs. Nearly eveyone says they have to cut the coils. Im doing the...- 1
- 0
-
bmcgc · updated
-
Clutch z bar install
Vintage Mustang ForumI just got the new T5 tranny in and I’m moving on to hooking up the z-bar linkage. I have everything loosely in for measurements but I’m stuck with the lower rod that engages the clutch fork. How do I move the clutch fork back far enough to let me install the rod? It can’t be done with your bare...- 1
- 14
-
xela.zue · updated
Join now to ask and comment!