Vintage Mustang Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
6,630 Posts
Discussion Starter #1
I need some fittings and about 10 ft each of -6 and -8 AN braided stainless. Anyone have any secret cheap sources?
 

·
Premium Member
Joined
·
1,393 Posts
I can tell you that it isn't cheap! I bought a bunch of hose and fittings on E-boy, as a lot......

Other than that, Summit or Jegs is about the best you'll do.......

Gary........::
 

·
Registered
Joined
·
152 Posts
How do you cut that stuff(braided stainless)? I ended up taping the ends and cutting them with a dremel cut off wheel. Is there a easier way?
 
G

·
Guest
Joined
·
0 Posts
I don't know if its easier but I tape up where I want to cut and then get my hammer and chisel out. It takes about two hard hits and its cut, if you have a sharp chisel. ::
 
1 - 5 of 5 Posts
Top