Vintage Mustang Forums banner
1 - 1 of 1 Posts
G

·
Discussion Starter · #1 ·
Bill, The 68 Shelby oil pressure gauge is now working properly. The problem was the sending unit (all 4 of them). The 68 Shelbys used a Stewart Warner (as opposed to the standard Ford unit) sending unit #353BC 12-V which was matched to the gauge. The sending unit was originally designed for a marine application hence the rubber boot. There are only a few units available and they can be had from Pony Car Specialists in Carroll, Ohio, 614-837-3820. I dealt with Dave at Pony Car he was knowledgable and very helpful.
Thanks for your help in the past.

Ron
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top