Vintage Mustang Forums banner
  • Hey everyone! Enter your ride HERE to be a part September's Ride of the Month Challenge!
1 - 7 of 7 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
We are offering Ford Mustang and Cougar 69-70 Correct Front Floor Pan Patch Panels.

These panels are correct for 69-70 Ford Mustangs 302,429 and Shelby Cars and also 69-70 Ford Cougars.

We made the tooling for these Left and Right side panels because the china ones are not correct and are not available.

These are American made in Ohio from 19 Gauge Steel. You will receive a Left and Right Panel that will have the lip that is bent up to butt up against your inner rocker.

You will have to trim and fit the other 3 sides.

If you are interested in these correct looking patch panels please drop us a message.

The 2 photos shown are where we have installed these new panels in our personal 69 Boss 429 Mustang car we are restoring, giving it that original look.

Note the stiffening ribs are the correct shape and NOT round like the china ones.

Thanks for Reading and Looking we hope you will appreciate our efforts to reproduce these Correct Looking panels.

Price is $200 each

Hood Automotive lighting Grille Automotive tire Motor vehicle
Motor vehicle Bumper Automotive wheel system Automotive exterior Automotive tire
Automotive tire Tire Grey Tread Motor vehicle
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #5 ·
For two bills each, they should be a lot less wrinkled up than what you're showing IMO.
Can you mark/show what the difference is on one of the photos above?
The difference is the ribs in the Chinese unavailable one is rounded and the original one is pointed. These are made exact to our all original Boss 9 with 6000 miles.
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #6 ·
For two bills each, they should be a lot less wrinkled up than what you're showing IMO.
Sorry I included you on a separate reply. If you look at any factory floor that is stamped and you will see the same thing. Look at the driveshaft tunnel and you will see much worse. Metal has to go somewhere. As far as the price, a die isn't cheap. They are made in the USA and most important available.
 

·
Registered
Joined
·
428 Posts
The difference is the ribs in the Chinese unavailable one is rounded and the original one is pointed. These are made exact to our all original Boss 9 with 6000 miles.
My question was not for you, was asking 66Ccode what the difference between 69 and 70 front floor pans based on his post.
69 is different than 70 in the front….
 
1 - 7 of 7 Posts
Top