Bullitt is on AMC Right Now!!
1 - 4 of 4 Posts
1 - 4 of 4 Posts
Join the discussion
Recommended Reading
-
65 351W swap - short waterpump
Vintage Mustang ForumI have a 351w in a 65. I have a home built SPAL fan shroud on the back of the radiator barely kisses the nub on the water pump hub. My pump has a drivers side exit hose. I would like to get a shorted waterpump hub length if possible. Do they make a shorter hub height pump? I found the short...- 3
- 80
-
mustangtyson · updated
-
Short vid of pulling a 67 out of a coop
Vintage Mustang ForumI pulled this poor '67 Coupe out of a collapsed chicken coop a couple years ago. It was too far gone to mess with and I sold it. I'm going after another one soon. Hopefully not as bad but we will see. Here's a pic of the next one.- 0
- 29
-
MarkMopar · updated
-
69 mach1 390 no drivetrain value ?
Vintage Mustang ForumWhat is a 69 mach 390 auto with no motor/trans worth these days.. really nice body but needs restored, very little rust! thanks- 13
- 442
-
Want to install electric or hot air choke on a 302 (holley carb)
Vintage Mustang ForumI have a 1965 coupe with a mid 70's 302 in it, Holley carb. I have been tuning the car and got her running great once warmed up, however on startup when cold she is rough and I need to engage the choke (car previously had manual choke which was not working properly) - with proper choke she...- 23
- 357
-
fan spacer needed.....
Vintage Mustang ForumNailbender and Kelly got me onto buying this Northern radiator and so far so good I hope but now I am in need of a shorter fan spacer,the one I have is 3 1/8 inches overall and I think I need 1/4 to a 1/2 inch shorter. I also had to massage the crossmember so the rad could fit without rubbing...- 7
- 165
-
C6ZZGT · updated
Join now to ask and comment!