[BugsBunnyMustang]

The passenger side fender has a nice 3 by 3 inch rust hole and 2 other pin holes.
My big question is do I fix the holes and move on or hang a new fender?
I kinda think I will pay close to the 150 to get the rust fixed right.
Any thoughts guys......

 

[HoustonGlock]

Is the one on the car original Ford? How bad is the rust? Pictures?

Original Ford and repairable, I'd spend the time and effort to repair it. Much better quality and fitment then aftermarket.

Sent from my SM-N960U using Tapatalk

 

[Lizer]

If it's an original panel, I will do whatever I can to save it unless it's too far gone. Reproduction metal will make you go to church.

 

[Lightning]

I agree on fixing the original if possible. However if youre paying someone else to do it, its probably going to cost more than $150.

 

[Huskinhano]

Even if you buy the repro fenders I'd still hold onto the originals for down the road.

 

[BugsBunnyMustang]

I agree on fixing the original if possible. However if youre paying someone else to do it, its probably going to cost more than $150.

That was my reasoning good work will be more than 150

 

[Nailbender]

That was my reasoning good work will be more than 150

Fix the original M'erican fender!

 

[HoustonGlock]

Post a picture of rust area and we can advise on repair worthiness

Sent from my SM-N960U using Tapatalk

 

[MWM]

When I did my rebuild I searched high and low for a original set of fenders. The re-pops back in the day weren’t known to have a good rep. If your handy, try cut and weld. You will be much happier! If you have to hire someone else, you will still be much happier. If at the end of the day you just have to have the rest-pop, send originals to me. Capeesh?

 

[Smileyg3]

Bought a replacement fender and regret it, very flimsy and does not fit right

 

[Israel]

Another vote for repairing the original if possible.

 

[kkupec02]

Always original if it can be saved.