Vintage Mustang Forums banner

C4 automatic tailshaft bushing

1822 Views 3 Replies 2 Participants Last post by  Guest
I need to replace the tailshaft bushing in the C4 automatic of my 1965. I keep hearing conflicting stories. Some say I need to remove the tail housing and some say it can be done by just removing the rear seal only. Can anyone give me an accurate recommendation? Any special tools needed? Thanks.
1 - 1 of 4 Posts
Remove the tail shaft, far easier for the home mechanic. Done it, does not take all that long. Biggest problem in trying to change it with the tail shaft on is the output shaft is there, and the amount of room you have to work in is the thickness of the side of the yoke.

68 GT500
68 1/2 CJ Coupe

MCA# 18519
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.