Vintage Mustang Forums banner
  • Hey everyone! Enter your ride HERE to be a part MAY's Ride of the Month Challenge!

1 - 2 of 2 Posts

·
Registered
Joined
·
6,911 Posts
Discussion Starter · #1 ·
OK....I finally installed a factory shift selector rod in between the C4 in my 70 and the shifter. It's nice to have no slop in the shifter!!


Problem#2 ........the shifter wont go all the way from park to low1 no matter where I adjust the linkage to. I looked for interference under the car and didnt see any....with the linkage away, I appear to have 6 detents, so I dont think it's an early C4 (it also has the 26 spline input shaft!!)



So...does anyone here have some means of ID'ing the lower bolt on levers on stang automatic shifters?????


Length? Markings? ETC.?


Thanks guys.



P.S.
 

·
Registered
Joined
·
6,911 Posts
Discussion Starter · #2 ·
I called NPD and bothered them; they say there are different shifters for C4 and C6 equipped cars.


So now the question is; will any C4 compatible shifter lower arm swap into mine?


Looks like a prime time to get the bushings for the shifter and make whichever one cleaned up and smooth operating.


Maybe I just need to get another and hang on to the C6 variant I have....


Then again, maybe I just need to buy a megashifter, LOL!!!
 
1 - 2 of 2 Posts
Top