Vintage Mustang Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
191 Posts
Discussion Starter · #1 ·
Wondering how difficult it is to change the shaft seal where the neutral safety switch enters the tranny, C4 1969, hooked up to a 302? We have various and assorted leaks, this is one and changing the pan gasket will be a no-brainer, just not sure how hard this shaft's seal is. My shop manual doesnt really show a clear picture of it, can it be changed from the outside, or is it done from the inside somehow? Any suggestions will be appreciated. TIA
 
G

·
It's easy if the pan's off. Pull the valve body. There's a large nut holding the selector shaft in. remove the shaft, install the seal, re-assemble... Viola!
 

·
Registered
Joined
·
191 Posts
Discussion Starter · #3 ·
Thanks, sounds like we can handle that!! Happy Trails!
 
G

·
I ditto the previous info. I replaced mine about a year ago, worst part was all of the pan bolts. I has to disconnest the linkage, and pull the NSS to get enough moving room, but it swapped out very easily.
Dan
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top