Vintage Mustang Forums banner
1 - 2 of 2 Posts
G

·
Discussion Starter · #1 ·
I've been thinking about resto-modding a tilt/cruise control column into my 'stang. I've looked into a few and have some definite possibilities. However, I'm not sure if the shaft itself will be too long.
So, the question is: can a steering shaft be shortened? If so, how?

Visit my homepage for Repair info, with pictures!
http://home.dencity.com/mustangcub
 

·
Registered
Joined
·
652 Posts
You could cut down the shaft to the length you need and then rejoin the two shorter
pieces using a needle bearing universal joint or solid coupler. Flaming River sells both.

Rich
'67 C-code 'vert (Dees67)
'69 GT FB (project car)
Check out my band http://www.brickyardblues.com
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top