Vintage Mustang Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1,243 Posts
Discussion Starter #1
My Edelbrock 600 carb has sticking floats , stuck down as it is flooding . Is there anything short of removing the top that can be done.
I screwed up and didn't put any gas treatment in it for the winter ,
 

·
Registered
Joined
·
786 Posts
I have an Edelbrock 600. It take about 2 minutes (or less) to take the top off. When you do the floats lift out of the bowls with the top. Should be easy to clean from there.
 

·
Registered
Joined
·
1,620 Posts
X2 Just be carefull not to damage gasket or buy a new one ahead of time.
 

·
Registered
Joined
·
2,655 Posts
Before putting it back together, you might want to check the level of the floats. I believe its supposed to be 7/16. You can use that size drill bit as a gauge.
 
1 - 4 of 4 Posts
Top