Vintage Mustang Forums banner
1 - 1 of 6 Posts

· Registered
363 Posts
Discussion Starter · #1 ·
I'm going to start collecting parts for some work on the stang over the winter time. I'm currently thinking about slapping on a new intake and carb. My 67 289 has the stock equipment.

I may rebuild the engine within the next year or 2 and probably want to build it up a little bit. Nothing too exotic, but I'd like to get a carb and intake that will work well in stock form and also on a mildly built 289.

Any suggestions? A friend did say that Edelbrock would do me well a 600 CFM carb and the performer intake.

1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.