It would not fit under my stock hood but will fit under a teardrop bubble hood
I know the ebay price is out of site but i am not going to use it.
it is a early 65/64 casting as it has the thermostat pocked in the manifold. Needs a c4 flat thermostat housing.
Live in Hamburg - my daughter lives in Henrietta and girlfriend's kids live in Fairport. I'll probably going there more often with twins coming soon . I'm addicted to multi carbs and that manifold would look nice sitting on my shelf lol..
Live in Hamburg - my daughter lives in Henrietta and girlfriend's kids live in Fairport. I'll probably going there more often with twins coming soon . I'm addicted to multi carbs and that manifold would look nice sitting on my shelf lol..
It was originally a 65 6 cyl car. Now a 302 5 spd.
The bell crank rod is nowhere near the wiring loom at max throttle pedal position. It is atleast 2 inches from it.
With the link is the lower hole I have about a little less than an inch of space between the bell crank arm and the engine/manifold.
My current linkage is 10.5 inches center to center.
While checking the above I noticed that the carpet under the throttle pedal/crank arm is very thick. I wonder if the thick carped/padding is preventing the crank from traveling to its full extension.
put a 2x4 or something similar between the pedal and the seat so that the pedal is on the floor.
then adjust the link to the carburetor so the carb is wide open
I have one from i think a 66 390 fairlane. Not sure if it was auto or manual
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Vintage Mustang Forums
4M posts
89.2K members
Since 2001
A forum community dedicated to vintage Ford Mustang owners and enthusiasts. Come join the discussion about restoration, modifications, NOS parts, troubleshooting, VIN codes, and more!