You can contact Auto Custom Carpet... the makers. I did.
After looking at all the samples at my local dealer I choose a Corvette sliver material that matched the interior I was doing on the car below. They simply took that material and put it in the Mustang molding machine
Don't remember the cost and it was approx 10 yrs ago
This is my first Ford inline 6, 200ci in a 1970 ford falcon. I have a question that will be simple for everybody here but I'm not afraid to look dumb and need some help. I am ready to remove the rocker arm assembly and push rods to move onto removing the head, but before I turn any bolts...
My hydraulic clutch master screwed up the last time I used the car and barely got it in the garage for the winter before it died. Since they are offset from the hole in the pedal, they do tend to go out, I learn by reading posts that after about 4k miles they die, unless you get the Modern...
Original AC in 1966 Mustang (York compressor) that still had original refrigerant since at least 1984 and worked well until last year at which time the system had to be opened so all the R12 now gone - what would I need to do to convert to 134A refrigerant? Thanks.