Vintage Mustang Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
52 Posts
Discussion Starter · #1 ·
I have a 66 mustang with a center console with a 4 speed shifter plate insert on it. When i put in my t-5, will the hole in the floor and hole in the center console line up. I will be using the replacement "look-alike shifter", so will that fit in the console too? Also are the dimensions the same for a t-5 and tremec transmission? I dont want to do any cutting.
 

·
Premium Member
Joined
·
2,699 Posts
I've done the swap with no problems. The only issue and it's a small one is that the console shift plate hole favours one side a little
 

·
Registered
Joined
·
1,266 Posts
I used a B&M Ripper Shifter with an original T-5 Shifter lever. It fit fine.

http://www.midnightdsigns.com/james/images/console%20003.jpg
 
1 - 3 of 3 Posts
Top