Vintage Mustang Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
39 Posts
Discussion Starter #1
Folks: I am considering a front-to-back replacement of my exhaust system ( '67 428 FE). I need a shop that can properly fit either FPA or other TRY Y headers for maximum ground clearance, and fabricate or "modify" a pre-fabricated 2 " system all the way back. Any suggestions / recommendations would be much appreciated.
 

·
Registered
Joined
·
580 Posts
Unfortunately, I can recommend a shop, but it may be better to build the exhaust system from scratch since it would be cleaner & likely just as expensive. Also, I would think 2" pipe would be a bit small for your 428. Depending on your performance needs, mandrel bent 2.5" pipe may be the smallest to consider.
 
1 - 2 of 2 Posts
Top