Vintage Mustang Forums banner
  • Hey everyone! Enter your ride HERE to be a part August's Ride of the Month Challenge!
1 - 1 of 1 Posts

·
Registered
Joined
·
678 Posts
What did you use for parts? I was going to do that on my car, but the area for the Master is close and I could not find a real reliable source for the hydraulic throw out bearing. I wasn't sure about using a push or pull cylinder. Thanks

Neil
http://communities.msn.com/Myhtrd/homepage
http://albums.photopoint.com/j/View?u=1595545&a=12154418&p=44311400.jpghttp://albums.photopoint.com/j/View?u=1595545&a=12154418&p=44127162.jpg
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top