Congratulations USA....
1 - 7 of 7 Posts
G
Guest
·Guest
Joined
·
0 Posts
I just wanted to add my congratulations too.
And be careful with those fireworks, I don´t want to read about any doofus(es) tomorrow!
Have fun!!!
Anders Olsson
And be careful with those fireworks, I don´t want to read about any doofus(es) tomorrow!
Have fun!!!
Anders Olsson
G
Guest
·Guest
Joined
·
0 Posts
Thank you its been a hard year on all. 
Joined
·
1,103 Posts
A bit late, but congratulations folks!
Gary
Gary
1 - 7 of 7 Posts
Join the discussion
Recommended Reading
-
Rear Axle
Vintage Mustang ForumSo I installed these new Grab a Track Springs a few years ago. I have new wheels and tires. Is it me or is the rear tire sitting to close to the front of the wheel housing? It is the same on both sides. Any suggestions will be greatly appreciated. LJ- 2
- 68
-
Bump Steer
Vintage Mustang ForumSo my 1968 mustang has an issue with Bump steer. So I have a bump steer gauge and been getting readings that show that it is toe in on both compression and rebound. I keep reading that "tie rod needs to be lengthen". What does that mean "tie rod needs to be lengthen"?- 1
- 63
-
KeithM · updated
-
How to avoid a money pit... (disregard title)
Vintage Mustang ForumOk I’m going to try and make this very loaded question alittle less loaded. Right now I’m a college student on a hard budget. Makes things difficult. I’ve heard so many say they wish they dropped the cash on this or that instead of cheaping out. I want to know where I can cheap out and where I...- 97
- 1K
-
Jr_Palm · updated
-
Help identifying these steel wheels
Vintage Mustang ForumHi all, Below are pics of the steel wheels that came with my car. The previous owner was pretty adamant about having concours/period correct stuff but I don't know what these are...can anyone shed some light? I could not find too many markings or stamps. The beauty ring and the center caps...- 10
- 257
-
Issue with upper control arm removal :/
Vintage Mustang ForumHi Guys, I seemed to have run into an issue regarding the coil spring and removing the upper control arm on my '68. Can I use a macpherson spring compressor to pull up the bottom coil?- 8
- 202
Join now to ask and comment!