Vintage Mustang Forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
45 Posts
Discussion Starter #1
Hi all,
I put in my console (66 no a/c) and there is about a 3/4 inch gap between the shifter and shifter console plate (pic attached). I searched the forum and this same thing was a discussion about 10 yrs ago. The one option then was removing pad around console area. Any other ideas?
Thanks,
Ed
 

Attachments

·
Premium Member
Joined
·
3,753 Posts
Maybe using spacers and longer screws for the shift position indicator?
 

·
Registered
Joined
·
246 Posts
Is your car a convertible? Convertible consoles were scalloped along bottom of both sides to better match the floor. Not sure how well a coupe/fastback console would fit a convertible. Do you have the proper shifter components?
 

·
Registered
Joined
·
1,015 Posts
I went through the same thing, haven't fixed it yet. I think the difference is the selector lever plate.
Only pic I could find, should be able to enlarge it.
757401
 
1 - 7 of 7 Posts
Top