Vintage Mustang Forums banner

Convertible top boot padding info - anyone?

2389 Views 5 Replies 3 Participants Last post by  timbeam
I was reading with some interest a post detailing the fact that there was, I assume from the factory, a sort of foam pad that went between the top and the boot when the top was down? This seems perfectly logical, as I've wondered how much longer it will be until my boot ends up with 2 wear holes in it from the upper frame edges.

Where did this foam boot sit when the top was up? Was it a part of the top itself or was it in the top well? Also, does anyone know of any pictures of this thing? I've never seen it in any of my books.

Finally, can one buy this thing reproduced? If not, I'd definitely be interested in making one...

Visit my repair page for Repair info, with pictures!
1 - 1 of 6 Posts
The nicest boot I`ve seen is made by TMI ! Pads are built in and covered by second layer of vinyl.
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.