Correct Finish for Seat Tracks?
Join the discussion
Recommended Reading
-
Mysterious Electrical Gremlins
Vintage Mustang ForumHi. So, I've been having intermittent engine cuts out, but would fire straight up again after. Recently it's been harder to start and keep running that I haven't dared drive anywhere. Have set timing, new distributor, plugs, leads and coil. Latest addition was electronic ignition and after...- 13
- 328
-
Time to Move On
Vintage Mustang ForumI first want to thank all of you who have helped me along the way. This site has been a huge source of helpful information. But, I decided that I wanted to jump into the Chevy truck scene. I posted my car up on FB and Ebay, and it sold in 6 minutes. Someone in Australia bought it! I advertised...- 2
- 0
-
jgrote · updated
-
Picking an engine?
Vintage Mustang ForumI would like to hear some opinions before I purchase or build an engine. I'm getting close to the point of an engine. I have a core for a 1976-302 or a 1984-351 not sure of which one I would like as my finished engine. I am not building a show car, but a nice muscle car to drive on weekends. I...- 12
- 457
-
7Dpilot · updated
-
Louver tabs
Vintage Mustang ForumI assume these are tabs to mount a window louver. Are these original? Do they still make a louver that uses these? How do you remove them, are they hooked on the glass?- 10
- 199
-
[email protected] · updated
-
Bent Z Bar
Vintage Mustang ForumEvening, This is the top of the Z bar that connects to the push rod on the clutch pedal. Is it supposed to be bent towards the engine like this? This is on a 67 in line 6. The other day a pin snapped on my pedal assembly and I learned that the whole assembly was being pulled apart by some...- 12
- 235
Join now to ask and comment!