Vintage Mustang Forums banner
  • Hey everyone! Enter your ride HERE to be a part September's Ride of the Month Challenge!
1 - 2 of 2 Posts

3,179 Posts
Discussion Starter · #1 ·
Just remembered my '65 garage shelf had this problem after looking at it again. Right at the outer edge of the corner between the upper and lower door hinge is a big Ol' humongus crack about 8" long and about 1/8" at the widest. I guess I'll have to remove the door, beat the separated part back together and weld it together.

Question: Should I weld in reinforcement behind it or will a solid butt weld do the job?

Maybe I should take this to a pro since I never even taken welding classes and just have a small Lincoln Weld Pak 100 with flux core wire.



Dean T

Shikatta Ga Nai - "It cannot be helped"
1 - 2 of 2 Posts