Joined
·
1,617 Posts
Is a cast steel crank lighter than an iron one? THANKS
Crank ?
1 - 2 of 2 Posts
1 - 2 of 2 Posts
Join the discussion
Recommended Reading
-
Another project maybe
Vintage Mustang ForumAbout 3 yes ago I was at a large junkyard in the sticks removing elec window regulator from a 2003 va conv ro ro repairs on 1 I later gave my 16 year grandson & I ask the guy helping me if they had any mid 60 cars or mid 50 ford trucks on the yard. He said there was an old ford was in the woods...- 4
- 192
-
Front sway bar question
Vintage Mustang ForumI have a 1 inch front sway bar on my 66. The bolt on the lower control arm that goes through the sway bar and the sway bar are not at a 90 degree angle to each other. This is causing it to want to push the rubber insulators out. I did use the Ford style insulators, Not the hard ones that came...- 13
- 152
-
68 antenna fender hole size
Vintage Mustang ForumI sold my old fender last year and forgot to get the antenna hole size and measurements where to drill it. Can anyone help? Thanks, Ed- 0
- 0
-
droptop119 · updated
-
Canton Pan Question?
Vintage Mustang ForumHi, I bought a Canton 15-630s pan, their girdle, their windage tray, and their 15-611 pickup. I measured the pickup to pan clearance, and it was too close at 3/16" The pickup height was 7 15/16" and the pan depth was 8 1/8" (including the gasket). I measured the pickup height by using two...- 12
- 219
-
Valve terrain geometry and push rod length.
Vintage Mustang ForumI’m going through the process currently. I’m using this video as the procedure. I have basically a stock 289. Cam information is below. I’m changing to Pro Comp roller tip rockers. My first issue is which push rod length checker do I need. I need a base line. I know stock push rods are...- 19
- 468
-
Stangfire · updated
Join now to ask and comment!