Vintage Mustang Forums banner

1 - 3 of 3 Posts
G

·
Guest
Joined
·
0 Posts
Discussion Starter #1
Is there any source that gives the OD of the crankshaft pulleys for the 65-67 cars? Also, would a three groove pulley be used on a non A/C car?
 

·
Registered
Joined
·
3,848 Posts
Three groove pulley is used for a ps and ac car I believe.
My single groove pulley is about 6-1/4 dia.

65 FB "J" 302 lots of mods. 94 GT K&N only.
 
G

·
Guest
Joined
·
0 Posts
Discussion Starter #3
Thanks for the note. I was thinking the three groove was for PS and AC. I am not going to be adding the AC and have a 2 groove that is slightly smaller than the 3 groove.
 
1 - 3 of 3 Posts
Top