Vintage Mustang Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
757 Posts
Discussion Starter #1
Has anybody done the swap 1 kit?

I currently have CSRP kit 2 with the full Granada deal, and would like to see if anybody has any measurements of how far the caliper sticks out past the middle of the rotor. I just installed my TCP R&P kit and the granada cliper is hitting the cradle.

Im thinking this might be my issue, and if anybody has a Swap 1 complete, I would love to see a picture similar to mine, or even better a measurement. Maybe I can organize something and change to a Swap 1 if it is indeed my issue. I have my factory v8 power drum spindles.

Any help would be appreciated

Thanks!
 

·
Registered
Joined
·
3,355 Posts
If you haven't got it yet and can wait a couple days, I can get a picture for you. Just PM if you need it.
 

·
Registered
Joined
·
757 Posts
Discussion Starter #5
Thanks for the replies guys,

Turns out the issue was that my old setup (swap 2 - granada) had rear mounted calipers which hit the lines on the cradle.

I have since sold that kit and purchased swap 1 - KH calipers which mount to the front of the vehicle. This will completely fix my issue regarding hitting the lines. It will also fix my issue relating to tie rods (hopefully)

Will post some pictures once I am done with the brakes later this week/weekend.

Thanks again for the replies!
 
1 - 5 of 5 Posts
Top