deal of a life time

1 - 1 of 1 Posts

Guest

Joined Jan 1, 1970

0 Posts

Discussion Starter • #1 • Mar 19, 2001

well maby not but it was a good deal. I was at anual HIPro swap meet today and I picked my self up a 73 running horse emblem and a 67 side 289 baging for only a buck. now all I need is a car to put them on ! oh well maby next year

1 - 1 of 1 Posts

Recommended Reading

Turn signal grief

Vintage Mustang Forum

Just finished replacing my turn signal switch for the third time— I go to test out the blinker, and it starts smoking. Doesn’t work at all now. 90 dollars and three switches later, I’m getting REALLY TIRED of these [email protected] things... After the second one blew out, I did some extra research. People...
- 19
- 439
- alex1965 · updated a moment ago
68’ Differential Housing Question

Vintage Mustang Forum

8” Rear on this 68 Coupe and I was wondering if this front part of the carrier where the pinion is (smaller one with 3 bolts showing in photo) Has it’s own gasket underneath and can unbolt without taking the entire carrier and axles out. It appears it’s starting to seep a tiny bit now that...
- 7
- 205
- jsbenami · updated a moment ago
Speedometer cable and drive gear on top loader

Vintage Mustang Forum

Ok , so after a lot of help on a different thread about gear ratios where I was not going to be happy with the close ratio top loader I was putting in to replace my 3 speed, I sold the close ratio and purchased a wide ratio with the hurst shifter and linkage, supposed to have been rebuilt and...
- 11
- 193
- 1
  1beautifuldaughter · updated a moment ago
Can you recommend a good mechanic in Manassas/Northern Virginia?

Vintage Mustang Forum

I have a stubborn engine vibration issue. I think its the the damper, but am intimidated a bit by the install process. I'd have no issue taking it to a mechanic knowledgeable on these old 289s. So if you know a good tech in the Manasass/Norther Virginia area, please let me know.
- 3
- 103
- E
  Ed_Negron · updated a moment ago
Show me your trunk!!

Vintage Mustang Forum

I'm looking for ideas to spruce up my bare metal trunk. I'm not keen on dropping 500 bucks for the plastic and fabric MTF kit, so I'll make my own. No tire in there for me =) BTW, anybody have suggestions of what carpet to use? I'm thinking plywood core panels wrapped in carpet ... unless you...
- 44
- 2K
- DoctorC · updated 17 m ago