Vintage Mustang Forums banner
  • Hey everyone! Enter your ride HERE to be a part September's Ride of the Month Challenge!
1 - 4 of 4 Posts

·
Registered
Joined
·
95 Posts
Discussion Starter · #1 ·
Does anyone have any pics or info on a dealer installed dual exhaust system for a 65 SJ A code mustang. I'm looking for hanger points,type of hardware used and muffler demensions. Also, if trumpets were ordered would the dealer use the GT hardware and hanger. Thanks, Glenn.
 
G

·
The simple fact of the matter is that if a dealer did actually install a dual exhaust system, almost any combination of hangers and clamps would be possible.
 

·
Registered
Joined
·
95 Posts
Discussion Starter · #3 ·
How would they normally attach the mufflers to the floors, with sheet metal screws or backing plates? Glenn.
 

·
Registered
Joined
·
6,807 Posts
vonzeek said:
How would they normally attach the mufflers to the floors, with sheet metal screws or backing plates? Glenn.
With a dealer installation I would expect that they would have just taken it down to the local muffler shop (Midas, Jiffy.....) and had them install a system so any possible combination of attachment and plumbing would be possible.

Would have been quicker and possibly more profitable this way. Anyone every see dealer paper work where the dealer added dual exhaust and used factory (not the over the counter kit) parts?
 
1 - 4 of 4 Posts
Top