Vintage Mustang Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
446 Posts
Discussion Starter #1
When we cut out the floor, we noticed the inner frame patch on the drivers side was rusted. the frame rails are dented up from jacks, so I decided to replace both sides while im this far. Has anyone ever replaced the inner frame patch on a 67 or 68 ? Any advise?
 

·
Registered
Joined
·
446 Posts
Discussion Starter #3
inner frame patch is the part of the frame that connects to the frame rails located under the toe board part of the floor pans. You can see a picture of it in California mustang magazine and im sure others have it.
 
1 - 3 of 3 Posts
Top