Vintage Mustang Forums banner

1 - 5 of 5 Posts

·
Banned
Joined
·
5,578 Posts
Discussion Starter #1
I need a autolite/motorcraft distributor center shaft. Rust free, but dirty is fine. I'll take a dizzy without points, condensor, cap, vacuum advance.... all I need is the center shaft in good shape! If you have an orphaned part or dizzy that's not worth the time for a rebuild, I can use it. Looking for it on the cheap, with gratitude.
 

·
Registered
Joined
·
1,700 Posts
Hi Steve,
I'll check my "stock" on Friday, but chances are I have what you are looking for. I'll give ya a call Friday afternoon and let ya know for sure.
 

·
Banned
Joined
·
5,578 Posts
Discussion Starter #3
Thanks Dean! I'll give you the whole, sad story later on.
 

·
Registered
Joined
·
4,692 Posts
what is the aplication, the center shafts are different from the 289 to the 351. the 289 has a 1/4 inch female allen hole for the oil pump shaft & the 351 has a 5/16
 

·
Banned
Joined
·
5,578 Posts
Discussion Starter #5
Quite right, and I should have been explicit, rather than expect people to go through the bother of looking at my profile. It was for a 289.

It looks like Dean has taken care of my current problem, though... thanks for (what I assume) was going to be an offer to help out!
 
1 - 5 of 5 Posts
Top