Vintage Mustang Forums banner

1 - 1 of 1 Posts

224 Posts
Discussion Starter #1
I asked this question before, but didn't get a lot of response on it. So, here goes again.....

I'm ready to put the distributor in my 289 EFI conversion. I'm still using my old cast iron flat tappet cam, so I need to use a distributor gear that is also made out of cast iron.
I've got an EFI distributor that I think was made in 1984. The part number stamped on the distributor is E4ZE-12131-AA. There is also a sticker on it with the following numbers:

E7SE-12A332-CA W/MOD

I need to know what year this distributor is, and what the gear is made out of.
1 - 1 of 1 Posts