Vintage Mustang Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
3,483 Posts
You can replace the rear seal without pulling the tail housing. As that the output shaft of the tranny will extend out beyond the seal about 3/8ths of an inch, you'll need some type of way of tapping the seal back in squarely, uniformly.... such as a 2X4 with a hole cut in it just big enough to clear the output shaft.

Tom Kubler, Long-time Mustang Enthusiast & San Antonio Mustang Club Founder
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top