Vintage Mustang Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2,881 Posts
Discussion Starter #1
spraying Zero Rust (thinned per directions) with a detail HVLP gun? My compressor only puts out [email protected] and [email protected] Most of the detail guns I've seen require somewhere between 3-4CFM @40PSI. Is this a bad idea? I'm getting ready to paint the engine bay to look good, and I'm afraid that using a brush won't turn out right (after seeing the results on the cowl section). Also, what size tip should be used? They come anywhere from 1.0 to 1.7. Comments please.

Thanks,
Gregg
 
1 - 2 of 2 Posts
Top