Vintage Mustang Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
4,897 Posts
Discussion Starter #1
Repo fiberglass panel, the one that mounts above the trap door on a '67/68 FB? When I stripped the paint off mine the easy off and scrubbing put some nasty gouges in the panel. Is there any way to fix this other than replace it, if I can find one?
 

·
Registered
Joined
·
7,756 Posts
I do think this is available, but not sure if it is alone or with the other pieces, check Laurel Mountain Mustangs.

Where do you think the gouge came from? I am planning on cleaning all of my fiberglass parts this way soon.
 

·
Registered
Joined
·
4,897 Posts
Discussion Starter #3
I think I scrubbed one spot to hard, that was the only panel I had any issues with. I saw Laurel mountain had a kit wih all five pieces on Ebay, but I only need the one. All my other panels came out fine. I looked in the Mustangs unlimited catalog and they have the 5 pieces kit as well. Still witing on the NPD site to launch, really slow today. I have the catalog around here somewhere, I think.
 

·
Registered
Joined
·
4,971 Posts
All of the rear 67-68 FB rear pieces are now available.

Check around.

Dave
 

·
Registered
Joined
·
1,552 Posts
All of the reproduction panels rear that I've seen advertised are made of ABS plastic, not fiberglass.
 
1 - 6 of 6 Posts
Top