Vintage Mustang Forums banner
1 - 2 of 2 Posts
G

·
Discussion Starter · #1 ·
Whats the trick to lining up the doors again after fixing the hindges ? I marked them
but the marks arent clear. I have only done the bottom drivers so far.
It is a bit low and in too far at the top and out a bit at the bottom.
Thanks,
Tom

67 6 cyl coupe
 
G

·
Discussion Starter · #2 ·
The hinge to door bolts should take care of that, loosen and rotate top out, bottom in while lifting a bit
to get the height. A bit of trial and error.

66 Coupe, 289/2v, C4, CA Red
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top