Vintage Mustang Forums banner
1 - 2 of 2 Posts

· Registered
154 Posts
Discussion Starter · #1 ·
Ok,shot the inner and outer fender aprons on my 65 w/ the POR 15. Now I'm ready to apply the seam sealer and then the undercoat.Inside the little pockets at the bottom of the shock towers there are small holes.When I,m done my preperations I want to make sure these holes are open for drainage ,right?I know the factory wasn,t that concerned.Thanks everyone.

Yes, you want to keep those open. They are there to prevent build-up of dirt and grime in those little pockets under the control arm, but as you probably know, they didn't work too well.

1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.