Vintage Mustang Forums banner
1 - 3 of 3 Posts
G

·
Discussion Starter · #1 ·
Gentlemen Any tips on installing re-pop drip rail moldings on a 67 coupe? Thanx John
 
G

·
Discussion Starter · #2 ·
If they are like those on a '65, hook the top edge over and then apply even pressure downwards and they snap on. Make sure that u have the curvatures front and rear aligned first. (there is some overhang front and rear, about 1/2 inch as I recall) They may seem like they are distorting as you put them on, but they will be fine as you work your way along. Good luck.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top