Vintage Mustang Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
115 Posts
Discussion Starter #1
in the never ending search for a drive shaft I went to the junkyard today, and found a drive shaft that is the correct length but, its for a newer explorer with an 8.8.

if I find the correct yoke for the trans will the u-joint work?

will the back yoke mate good with the 9 inch that's in my car?

I measured the yoke side to side and it was about 3.5 inches.
 

·
Registered
Joined
·
115 Posts
Discussion Starter #2
found the answer, it will work, they share the same universal joint.
 
1 - 3 of 3 Posts
Top