Vintage Mustang Forums banner

Driving along and the auto blew .....

Jump to Latest Follow

1 - 3 of 3 Posts
A

·
Registered
Joined
·
1,376 Posts
Discussion Starter • #1 •
Just made that up . Can't talk about woman in stages of undress



Australian Nat. Concourse
http://albums.photopoint.com/j/View?u=1584152&a=12055089&p=46900019&Sequence=0&res=high.jpg
http://albums.photopoint.com/j/View?u=1584152&a=12055089&p=46900020&Sequence=0&res=high.jpg
 
K

·
Registered
Joined
·
911 Posts
#2 •
What is with that mustang on the right. The coup in the McDonalds colors with no trunk lid? Was it in restoration or did someone turn it into a el-camino!

Mustang Parts makes a great addiction.
 
1 - 3 of 3 Posts
Recommended Reading
Read More

  1. First real outing with the 67’

    Vintage Mustang Forum
    After what seemed like forever (since October lol) finally got things straight and was able to take her out for more than a 5 mile test ride. A little Picnic lunch by the Tred Avon River then a ride over to Oxford for some ice cream a ferry ride across the river and the long way home. Felt...

  2. FMX Hesitates Going Into 3rd Gear with Heavy Foot

    Vintage Mustang Forum
    1971 Mach1 351C with FMX. Grabber yellow with Mach1 flat black treatment and stripes. Great car! I bought the transmission used for $250 and it works/shifts fine when I drive car normally, however if I jump on it or punch it, the tranny slips and engine revs up for about a second before shifting...

  3. 1965 Power Steering leak question

    Vintage Mustang Forum
    My new to me 1965 convertible has a power steering leak, I think this is a fairly common problem. The control valve is leaking. My question is should I remove it and install a rebuild kit, or just replace it. It seems to be a bit pricy at over $300, a good kit is around $70. Just want to...

  5. Bleeding brakes. Frustrated, got to vent.

    Vintage Mustang Forum
    So I'm trying to bleed my brakes after replacing my master cylinder. I got a 65 6 cylinder with four wheel drums. I've gone around the car 5 times trying to get the brakes bled. I'm doing it with my wife doing the press, open, close, release method and got out all the big bubbles I could see...

  6. jerky at slow speeds

    Vintage Mustang Forum
    64must Registered Joined May 15, 2014 37 Posts Discussion Starter • #1 • 18 h ago My 1964 1/2 289 mustang starts and idles ok. It backs out of the driveway ok. Accelerating slowing the car is very jerky. Stomp on the gas pedal and it takes off quickly and smoothly. The car has a fresh tune...
Read More
About this Discussion
2 Replies
3 Participants
Last post:
Opentracker
Vintage Mustang Forums
A forum community dedicated to vintage Ford Mustang owners and enthusiasts. Come join the discussion about restoration, modifications, NOS parts, troubleshooting, VIN codes, and more!
Full Forum Listing
Explore Our Forums
Vintage Mustang Forum General Discussion (Non-Vintage Mustang) Mod and Custom Forum Classic Mustang Wanted Ads Concours Forum
Popular Communities
Community avatar for Home Entertainment
Home Entertainment
1,280,000+ members
Join
Community avatar for Mountain Bike Reviews
Mountain Bike Reviews
450,000+ members
Join
Community avatar for Working From Home Forum - New!
Working From Home Forum - New!
25+ members
Join
Top