Vintage Mustang Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
235 Posts
Discussion Starter #1
Has anyone had problems with useing an edelbrock 1406 on a dual plane intake? What should I be using carb gasket with the four holes or the one big one?
 

·
Registered
Joined
·
1,194 Posts
No problem with the setup, but I did have to put a spacer because of the hot starts.
 

·
Registered
Joined
·
235 Posts
Discussion Starter #4
Is the spacer the same as the adapter plate? If I install an adapter plate do I need a gasket on both sides of it?
 

·
Registered
Joined
·
235 Posts
Discussion Starter #5
gt350clone, Dude you rock! I got the heat insulator gasket and it worked like a charm. I put one on this afternoon and the 67 fired right up on the first pull after sitting for a week! Thanks for the advice.
 
1 - 6 of 6 Posts
Top