Vintage Mustang Forums banner

1 - 10 of 10 Posts

·
Registered
Joined
·
496 Posts
Discussion Starter #1
I got my engine and the dyno results back today.
302.1 HP at 6250 rpm and 290.4 lb-ft torque at 4000 rpm
Keep in mind this is a engine that was built to basically stock shelby motor specs.

John
 

·
Registered
Joined
·
3,697 Posts
Not bad at all . Can't wait to get mine on a chassis dyno once the motor is broken in .
 

·
Registered
Joined
·
2,614 Posts
wow nice top end HP figures too ( 6250), got yourself a real wind happy small block , i like it .
 

·
Registered
Joined
·
3,848 Posts
I'd say that was very good. ::

Shelby/Ford advertised 306 hp and you're right there.

What will be interesting is if you also get a chassis dyno when you are ready. We can see the real loss of power between the crank and the rear wheels.

Congrats on the numbers and good luck. ;)
 

·
Registered
Joined
·
496 Posts
Discussion Starter #9
I am planning on doing a chassis dyno test when its done. I'm real curious about how much loss there will be also.
 
1 - 10 of 10 Posts
Top